12V 20A RV Boat Switch Panel Stainless Steel Push Button Switches with Red LED

Elegant Carbon Fiber Vinyl film with vivid 3D texture. Ultra Compact Panel Size / mounting holes compatible BEP's Contour Panel Series.

Screw hidden design with polished stainless steel bezel. 20A Anti-Vandal Stainless Steel Push Button Switches with backlight labels.

Easy fuse-replacing design - fuse holder retractable from the. IP66 - Protected against powerful water jets from all directions (when mounted). Faceplate:Plastic with Carbon Fiber Vinyl Film. Circuit Protection: in-line 15A ATP fuses pre-installed (per 2 branches).

Max Cumulative Amp: 25A per 2 branches. Disconnect all power (AC & DC). Cut opening for mounting location using the template provided. Connect the positive wire (red) to the DC power source (the batteries) and the LED negative feed wire (yellow) to a DC negative bus bar.

Connect the devices positive to the load terminals of the switches. Connect the negative wires of the devices to a negative bus bar. Apply desirable labels to the recessed area at corresponding branches. Mount the switch panel with the included self-tapping screws. Reconnect all the AC & DC powers. Turn on and off all branch circuits to check if the panel works normally. To replace fuses, use Flat screwdriver to pry open stainless bezel and inner panel as illustrated. Pull out the inner panel and replace the fuse. Simply push the inner panel and bezel back after desired fuses are replaced.

---